Commit c79d14c6 authored by Dustin Peterson's avatar Dustin Peterson

Minor fix.

parent fc4cd256
......@@ -740,7 +740,7 @@ If this command is used for specifying the power state machine (create_pmc), the
1. Left side is a power switch, a voltage regulator or a custom device. Right side is a power switch state, a voltage regulator state or a custom device state.
2. Left side is a power domain or a supply set. Right side is power state of the power domain, specifying the supply net voltages as in 2.1.
2. **-supply_expr** can contain only two operators *&&* and *==*. It is not allowed to use any other operator. Comparisons can be either:
1. Left side is a supply net. Right side is either *`{FULL\_ON, <voltage>}* or *`{OFF}*.
1. Left side is a supply net. Right side is either *`{FULL_ON voltage}* or *`{OFF}*.
3. A mixture of **-supply_expr** and **-logic_expr** is allowed and corresponds to a conjunction of both.
#### set_isolation, set_retention, set_domain_reset, set_clock_gating
......@@ -954,4 +954,4 @@ The constant registers, that are provided independent from the PMC configuration
The addresses might change, if the data bus is not large enough so that each field fits into the width of the databus -- furthermore are the addresses word-aligned, so changing the address witdth will also change the addresses of these fields. In that case, the fields are extended to their neighboured addresses.
In the subsequent address lines, configuration options like a timer configuration are available, but these are highly dependent on your power management configuration. Have a look at the specific documentation of your power management controller IP.
\ No newline at end of file
In the subsequent address lines, configuration options like a timer configuration are available, but these are highly dependent on your power management configuration. Have a look at the specific documentation of your power management controller IP.
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment